Next stop: Zurich @Modula26
Remote
Slash
@slash@merveilles.town
hometown
4.2.17+hometown-1.1.2
194
Followers
209
Following
18
Posts
Joined April 30, 2024
🎛️:
IRC:
irc.auti.sm
Posts
Interesting watch: Evolution of Blanka Electricity (1991-2020) https://www.youtube.com/watch?v=0WUl-GN9Roo #theObservatory
https://www.youtube.com/live/mAGg1kQtWXk live code VR
Replying to
@t36s@social.ordinal.garden
@t36s@social.ordinal.garden it took me way too much fussing about to get these 3d model footprints working, but I'm p happy with it atm. One thing I wish kicad made easier was getting a decent stacked board view working...
Replying to
@t36s@social.ordinal.garden
Mono channel strip with trim, gain, vactrol (photo resistor cv control), tilt eq and a master fader. Uses the same op-amp chips that are in Tascam Portastudios cause they sound good/bad. With a bit more added overdrive...
I've been holding off on showing this for a while, but I've been working on some Eurorack modules over the past few months. I just found out that I will be able to present them at Superbooth this year.
Going to try and grind out 2 more modules I have in the works by then...
Sick computer (literally) logo by @rek@merveilles.town
Replying to
@aartaka@merveilles.town
@aartaka They use formantic for a lot of that functionality, I'd argue much of it is detrimental. I was so annoyed by over-eager form tooltips that I had to disable them all together.
Replying to
@paupowpow@post.lurk.org
@paupowpow@post.lurk.org @offline@autonomous.zone @ojack@post.lurk.org @bgola@m.muito.top
Made a little screen capture of the stuff I had a go at showing last night