Post #2969374
2026-05-11 16:43 UTC
@Lunaphied@provably.online for connectors I just went with through hole / SMD / power / misc as separate drawer categories cos I couldn't think of anything better. I have a lot of connectors so four drawers (3 medium 1 small) was a justifiable allocation. misc is mostly panel mount and wire mount, but also stuff like test clips.
Replies (1)
-
@gsuberland@chaos.social 2026-05-11 16:55
@Lunaphied@provably.online for the IVAR drawers I designed dividers and cut them on the hackspace laser cutter (including some Unsafe Warnings branding!) super simple, just a long bit of MDF with tabs on the end, and a pair of end pieces with matching slots. no glue or anything, just slot together and drop in place. it's not even an interference fit - just loose. works fine. I put screw holes in the design in case I wanted to fix them rigidly in place but I've never bothered.