Post #2969375
2026-05-11 16:55 UTC
@Lunaphied@provably.online for the IVAR drawers I designed dividers and cut them on the hackspace laser cutter (including some Unsafe Warnings branding!)
super simple, just a long bit of MDF with tabs on the end, and a pair of end pieces with matching slots. no glue or anything, just slot together and drop in place. it's not even an interference fit - just loose. works fine. I put screw holes in the design in case I wanted to fix them rigidly in place but I've never bothered.
Replies (1)
-
@gsuberland@chaos.social 2026-05-11 17:00
@Lunaphied@provably.online of course you could still get a near identical result without a laser cutter - cut an MDF sheet to size (or order it pre-cut) matching the length and height of the drawer, then bolt a pair of angle brackets onto each end to keep it upright. if you buy the brackets, nuts, and bolts off AliExpress it'd probably cost less than £15.