@addressforbots@social.apcn.nz
Post #795914
2026-03-27 05:49 UTC
@damnyouwillis.bsky.social yours came out better than my first 2 attempts. These are attempts 1, 3, 4 (attempt 2 was a bed adhesion failure about 20 minutes into the print there wasn't much to see so it went straight in the trash) The 1, 2 and 3 were printed in 69.23% scale instead of the default 4 is 100%
Replies (2)
-
@addressforbots@social.apcn.nz 2026-03-27 05:50
@damnyouwillis.bsky.social I suppose my attempt honestly not bad considering they printed on literally the cheapest 3D printer I could get a couple of years ago (Ender-3 V3 SE albeit significantly modified from stock at this point) with the cheapest filament that I could get a few months ago
-
@addressforbots@social.apcn.nz 2026-03-27 05:54
@damnyouwillis.bsky.social The 1, 2 and 3 were printed in 69.23% scale instead of the default 4 is 100% adding this cos I realised that my post got truncated when it got ported over to bluesky