Post #3601074
2026-07-04 21:28 UTC
Surprised how well the Snapmaker U1 is able to print ABS *without* the chamber enclosure on top.
To be fair I use 12mm brims, manual double-layer round brims on corners and copious amounts of 3DLac adhesive spray to make it not warp too much. But still, kinda impressive.
Part 2/5 of a new hot air AC exhaust. Fortunately I can print the (way larger) cold intake out of PLA as it never goes above 50°C… hopefully.
#3DPrinting #SnapmakerU1
Replies (1)
-
@Natanox@chaos.social 2026-07-05 09:23
I fully expected this >400g, 11:30h ABS print to fail given the size. It came out perfect. nice. :blahaj: If these prints keep working I might be able to get the new AC ducts in place before the next heat wave. #3DPrinting