Post #3593306
2026-07-04 23:54 UTC
I’ll need to add some epoxy later, but this was easier than expected.
Replies (2)
-
@azonenberg@ioc.exchange 2026-07-04 23:55
@0h00000000@ioc.exchange is it bad that i can tell that big QFN is a TI part just from the font of the laser engraving?
-
@smellsofbikes@mastodon.social 2026-07-05 00:04
@0h00000000@ioc.exchange I've really appreciated how easy standard hot glue is to stick bodge wires on. You don't even need a hot glue gun. Clip a snippet off a hot glue stick, put it on the wire, touch it with the soldering iron, then once on each side so it flows out onto the pcb, and it's solid. It's also very easy to remove (fully) if need be, with a hard pull.