Post #2944418
2026-05-03 02:48 UTC
I 3D printed a BDM Frame (something like this https://www.ebay.com/itm/177795556850) and used the probes with pogo pins on, but every time I breath on the frame, the pins jump off their pads. There's no good solid way to keep them in place.
I'm close to just soldering on some wires, but if there's a better options. I'm all ears.
Replies (1)
-
@j_angliss@fosstodon.org 2026-05-03 18:06
I figured out what the device was... PC-3000 Spider Board. This wouldn't work in my situation as the pads I need to access are in the middle of a board. I'll probably just solder some jumper wires to the tiny pads and work from that. If I could get my eyes to cooperate today, cannot get them to focus on anything, so looking at a tiny pad is not going to help much. A tomorrow project.