Post #1764484
2026-03-07 11:23 UTC
@tinx @freecad Ooh, I needed that ! Thanks. I printed a small batch in PHA :D (so that if one is lost it will leave no micro-plastics in the end)
Replies (2)
-
@tinx@jit.social 2026-03-07 11:47
@EmmanuelG good thinking! It looks a bit less precise though. What is your experience with PHA? @freecad
-
@Feral_3D@mastodon.social 2026-03-09 11:50
@EmmanuelG @tinx @freecad I need this too. Saving for later. I feel like there should be an open-source repository of only useful 3D prints like this.