Elektrine lite

← Feed

@Olem@oldbytes.space

2026-09-26 15:23 UTC

#commodore #c1581 #retrocomputing Reason number one was that it needs a ROM chip with the right stuff on it. In my befuddeled state I burned the EPROM, put it aside and made a label for it - and then grabbed another random EPROM lying around on my desk, put on the label on that one and tried using it. No luck with that. Turns out I had tried to use this hilariously fake 27c128 (or is that what it is?) - it's blank and the wrong kind. Took me an hour or so to figure that one out. I need to clean up my messy desk, I guess.

Replies (1)

  • @Olem@oldbytes.space 2026-09-26 15:42

    #commodore #c1581 #retrocomputing The next reason was not on me: The drive powered up all right, but when it was connected to my C128, I would never get a blinking cursor after the READY promt on the computer. It would simply hang. The C128 checks for a bootable disk when it starts, seemed like something failed during that process. After a bit of experimenting I found that the 74LS14s from this batch was the issue. All of them causes the same error. A desoldered 74LS14 from a scrap board fixed the issue right away. The funny thing is that these 74LS14s passes the logic IC test in my MiniPro. So it seems that they are 7414s of some kind, but I guess they're not LS parts...I think Noel from Noels Retro Lab on YouTube had a similiar issue with a logic chp in one of his videos. Seriously, what's the point of faking stuff like this?

    Open ##4870755