Post #4458414
2026-08-02 01:25 UTC
I literally have a dissembled 3D printer in my desk right now that got the hotend entirely covered in some unknown carbonized substance… Probably from the filament.
Yet, that’s actually an easy fix and will cost a little bit because I’m choosing to replace that stuff.
At the same time, I have a paper printer around that I dissembled 3 weeks ago that is just waiting to be thrown away, because some parts made to break broke, and they cost as much as a new printer.
Replies (1)
-
@titanicx@lemmy.zip 2026-08-02 02:19
And yet I have at least three 3D printers sitting on my desk that are broken in various states that I have been unable to repair and unable to get working again including a brand new one that I literally just got a couple months ago I only started it up last week I’ve only done four prints on it five prints on it I think and it’s currently stating that it’s clogged even though I have cleaned every single piece of that damn thing and just replace the hot end this afternoon. But yet my inkjet printer which I haven’t touched has a absolutely zero issues.