Post #4263996
2026-07-31 03:28 UTC
@freya@social.highenergymagic.net there's an ASMI web interface that I can access via the FSP ethernet ports where I can set the baud rate and I made sure all that was right. I don't have an oscilloscope (I should get one) but the documentation says it's serial and I measured 15V with a multimeter (which seems right for RS232 and definitely not Ethernet)
Replies (1)
-
@freya@social.highenergymagic.net 2026-07-31 03:29
@noisytoot@berkeley.edu.pl yeah that smells like RS-232, yeah, and she's just not outputting anyth- wait wait wait hold the fuck on, if she's configured for an HMC, her primary serial won't output anything right? can you do a full factory reset on the FSP? I don't recall how to do that but I think it can be done from the front panel? that should(?) bring serial up