Post #3913998
2026-07-17 14:58 UTC
I should probably experiment with using lower $fn values, but increasing the size of the holes instead to see if that will work well, because increasing the value with a full keyboard increases render time dramatically.
Replies (1)
-
@overeducatedredneck@bitbang.social 2026-07-17 16:25
@minego@pdx.social you can also use low $fn and drill them out. It is extra pfaff to finish the part, but the holes are located and it covers both the foibles of OpenSCAD and the printer. Also, you can usually get away with using a pin vice and doing it by hand for better control.