Post #3116258
2026-05-04 21:04 UTC
@drfootleg@fosstodon.org @freecad@social.freecad.org I've tried to use TPU to make seals and have not been successful at all :(
Please provide an update after the rain!
Replies (1)
-
@drfootleg@fosstodon.org 2026-05-04 21:18
@cyclops_@fosstodon.org @freecad@social.freecad.org These don’t need to be completely water tight, just stop the water flowing straight out the end of the gutter instead of down the pipe into a water butt. I did also print a replacement o-ring seal for a pump up mist spray watering bottle as the rubber o-ring had split. This worked well compressed by the plastic screw thread and held pressure to make the sprayer work again.