Post #2934847
2026-05-10 17:58 UTC
@dos@social.librem.one @janvlug@mastodon.social Knowing the state the `lsusb` should show is valuable. From there on, flashing did indeed work. But it probably would not work from a VM because the USB redirect stops then the device identification changes during the script run.
This has cost me hours today.
Replies (1)
-
@janvlug@mastodon.social 2026-05-11 10:00
@codo@fosstodon.org Thanks for perseverance and and writing down your difficulties. Did you use the original USB power supply that came with the Librem 5? I think I have seen the ad infinitum cyclus you described as well a few times when the Librem 5 was very low on battery. But I think that the original USB power supply should provide enough power for the flashing process. @dos@social.librem.one