Post #2835798
2026-02-02 06:33 UTC
@sapphire@shortstacksran.ch Ive got a elegoo mars 4 ultra and the one is printed on that in the pic, but the lift speed/resolution was too much for the geometry
I think I may have got pretty close by slowing things down and doing 0.02mm slices. if you have any suggestions on slicers/supports, etc I'm all ears.
SLA is awesome though, I remember doing my first prints through shapeways SLA back in the day, what are you working with?
Replies (1)
-
@sapphire@shortstacksran.ch 2026-02-02 06:36
@anonny@pone.social I’ve got an LD-002h (the shittier halot one) and I’m pretty happy with it but yeah if you’re getting better results than I would with my printer (last rando I printed to see if my printer was still good, hence the pre-aged resin)