Post #2597543
2026-03-31 13:58 UTC
@lina@vt.social i did the apply one. But its back to its original state when i reboot it. Not your scripts fault tho, its working properly. It just my system that i suspect has a faulty settings. It also cannot retain the last buffer rate settings for my pipewire. So yeah. Have to make a clean setup from the start for the next update.
Replies (1)
-
@lina@vt.social 2026-03-31 14:00
@sandycorzeta@misskey.id It's normal for the settings to be lost after a reboot, you need the proper package to set it up automatically (the package adds all the hooks to automatically apply everything). The settings it applies are in RAM only. PipeWire buffer settings are a different story, that's going to be part of the guide I'm writing to go along with all this so it might help you too! ^^