Post #2504696
2026-04-28 20:57 UTC
@mid_kid@fosstodon.org These are high power capacitors so they would always be connected.
Replies (1)
-
@mid_kid@fosstodon.org 2026-04-28 21:02
@owiecc@en.osm.town In that case you should either draw the copper connecting both pins in the footprint (only cut the solder mask where the pins actually connect with the part!), or do the 1,2,3,4 setup so both can be connected in the schematic. Either way, in general the advice would be to follow whatever the datasheet does, and if it's a standard footprint shared by many parts, always separate pins.