Elektrine lite

← Feed

@Laberpferd@sueden.social

2026-04-30 18:41 UTC

@tiopalada@socel.net Multipart Calibration starts by reading absolute acceleration in X,Y and Z axe of a device that has been sat to rest. This also nulls the gyroscopes SQR(x²+y²+z²) gives the local acceleration of earth that is close to 9,81m/s² Some claculations with tan() determine the angles that the device has currently relative to true flat or true upright Calibration finished, start tracking mode

Replies (1)

  • @Laberpferd@sueden.social 2026-04-30 18:50

    @tiopalada@socel.net now any reading from the gyroscopes means that the device is rotating. The integral of measured readings is the new angle into which the device is now pointing From them you calculate back which x, y and z components the acceleration sensors are supposed to read The difference between actual readings and calculated values are the linear accelerations of the device in x, y and z direction. The integral of acceleration is the displacement, starting inertial mapping of position

    Open ##3136499