Post #156559

2026-01-26 00:20 UTC

So I’m broke and I buy the cheapest stuff. I bought an iPod Touch 6th Gen off eBay with a cracked screen and a bad battery for about $15. However, what I didn’t know was that apparently the battery was soldered to the Logic Board, which I should’ve looked up I guess… what can I do to tinker a bit with this device, make it a fun tech project, and still make it usable? It says working condition other than the bad battery…

Replies (4)

@wildbus8979@sh.itjust.works 2026-01-26 00:30

6th gen battery isn't soldered it's a connector. Check iFixit. Replacements are pretty cheap. Even with a cracked screen and dead battery 15$ is a killer deal for a 6th gen!

Open ##2145095
@monovergent@lemmy.ml 2026-01-26 02:57

If OP indeed has the 6th gen iPod **Touch**, not the classic, it won't be as rosy as most of the comment here suggest. From my experience replacing the battery on one, you need a hair dryer to loosen the glue and pry off the screen, then a soldering iron to replace the battery since its ribbon cable is directly soldered to the logic board. No storage expansion or custom firmware is available for such iOS devices, as far as I am aware. Also watch out for low-quality replacement batteries, the first replacement I tried only lasted around an hour on a full charge.

Open ##2145096
@etchinghillside@reddthat.com 2026-01-26 02:20

I’d be more concerned about the cost of the equipment to heat up and take the thing apart. Is that a concern?

Open ##2145097
@hateisreality@lemmy.world 2026-01-26 02:50

Super easy to replace the battery

Open ##2145098