Post #1297142
2026-04-16 07:09 UTC
A lot of overengineering: each section is independently driven by a mosfet, the mosfets are set on a custom PCB, the PWM is generated using a PWM module, and the whole is controlled by an esp32c3. The esp32 has espnow enabled and can be commanded to adjust the brightness.
Overengineered because I will probable never use the variable light mode this enables..
Replies (1)
-
@plantagolabs@mastodon.social 2026-04-16 07:15
Part of the reason is that the software is not quite done, and changing something is now highly difficult. But good enough is good enough. And everyone that sees it find it awesome so I will leave it at that. I now hope that the lamp will remain up there. Structural strength analysis is not something I did 😅